WolfVision VZ-15b User Manual - Manual (Page 12)

SCANNING SLIDE SHOWS
(all Visualizers)
Visualizer
Slide projector
A combination of a WolfVision Visualizer and one or more
slide projectors allows easy scanning of individual slides
or even whole slide shows (with cross fading).
Just project the slides onto a screen (or another white
surface), switch off the Visualizers light with the LIGHT
off key (#23) and tilt the reflector head to scan the slides
(as shown on the left). In this way it is also possible to
zoom in on details in a slide
LAMP CHANGER
(all Visualizers)
Wolfvision Visualizers are fitted with a lamp changer. If one lamp
fails, there is no need to replace it immediately. Just turn the
switch of the lamp changer (#8) on the front side of the unit to the
locked position. The spare lamp is now employed.
Thus there is no need to exchange a lamp during a presentation. The red light above the lamp changer switch
illuminates to indicate that the spare lamp (=the left lamp) is employed.
This acts as a reminder to exchange the other lamp (=the right lamp) for a new one when next convenient.
8
USING A VIDEO PRINTER
(all Visualizers)
WolfVision Visualizers can also be used for image capture with a video
printer.In this manner single pictures of papers and objects can be
made quickly. The lighting and focus problems are eliminated by the
Visualizers superb light and scan system. Just connect one of the
outputs of the Visualizer to the corresponding input of the video printer..
Connect a control monitor to the video output of the video printer and (if required) a second control monitor to the
Preview video output (#31 or #42) of the Visualizer.
READ-IN DEVICE FOR COMPUTERS
(all Visualizers)
WolfVision Visualizers are perfectly suited for working as 3-D scanners for
computers equipped with a Grabber Card. A Grabber Card can be used to
digitize a video signal, in order to store and process single pictures on a
computer.
Connect one of the outputs of the Visualizer to the corresponding input of
the computer's Grabber Card.(It depends on the type of Grabber card
which Visualizer signal should be used)
CONNECTING AN LCD MONITOR
(all Visualizers)
An LCD control monitor can be directly connected to the Visualizer using the Parallel port (#39).This port outputs
a 12 V DC power supply for the LCD-monitor.
The parallel port of the VZ-35b and VZ-15b also outputs a composite video signal for an LCD-monitor. This signal
is the same a the signal on the Preview output, which means that it is output even in the Image off mode.
A special cable for certain brands of LCD monitors is available from WolfVision. If you want to make your own
connection cable check out the pin description of the Parallel port on page 21.
12