WolfVision VZ-15b User Manual - Manual (Page 11)

VIDEO RECORDING
(VZ-15b and VZ-35b only)
v
id
eo
/
Y
/C
o
u
t
v id
eo
/
Y
/C
i
n
VCR "stop"
v
id
eo
/
Y
/C
i
n
v
id
eo
/
Y
/C
o
u
t
SWITCHING TO PLAYBACK OF A VIDEO RECORDER
(VZ-15b and VZ-35b only)
WolfVision Visualizers do not have an input switch because the following method of connecting a video recorder
is much easier and requires no switching at all:
Connect the video output (#32) or the Y/C (S-VHS) output (#37) of the Visualizer to the according input of the
video recorder. Connect the video or Y/C (S-VHS) output of the video recorder with the input of your monitor or
video projector.
When the video recorder is switched to
"Play", the picture of the video recorder
is shown.
When the video recorder is switched to
"Stop", the picture of the Visualizer
reappears (without any further switching).
video
out
video
out
video
out
video
out
video
in
video
in
video
in
video
in
Position: "Stop"
Position: "Play"
Visualizer picture:
video recorder picture:
Adjust the video recorder so that the picture of the Visualizer will be shown (Make sure that the input switch of
the video recorder is in the right position. If the video recorder has a TV-tuner switch to channel "0" or "AV"):
When the video recorder is in the "Stop"
position, the picture of the Visualizer
is shown (The signal is looped through
the video recorder).
CONNECTING A NUMBER OF MONITORS
o
u
t
in
in in in o
u
t
o
u
t
o
u
t
In this way a number of monitors can be connected. However if the signal is looped through a lot of monitors a
signal amplifier (distributor) should be used in order to achieve equivalent picture quality on all monitors. The
number of monitors through which the signal can be looped without a signal amplifier depends on the type of
monitor and on the cable length and quality..
Connect a control monitor to the Preview
output (#31 or #42) of the WolfVision
Visualizer.
Connect additional monitors to the outputs
of the Visualizer by looping them through
the inputs and outputs of each monitor (as
shown on the left).
A video recorder can be connected to the WolfVision Visualizer,
so that recordings on video tape can be made. Simply connect
the Composite video output (#32) or the Y/C output (#37) of the
Visualizer to the according input of your video recorder. When
using a S-VHS or Hi-8 video recorder use the Y/C output in
order to archive the best picture quality. Connect a control
monitor to the output of the video recorder.
The RGBS output (40) of the VZ-35b can be switched to YUV
for professional videorecorders with component input.by
simultanously pressing the
following keys: SAVE (#12), IRIS
dark (#19) and IRIS bright (#20).
11