WansView NVR901 - Manual (Page 4)

Figure 2 back view
¾ The device has three status indicator lights: red, green and blue in the
front;
¾ Please use the default power adapter which is 12V and provided by
the manufacturer;
¾ If forget user name or password, or did wrong settings; please press
the reset button for 5 seconds, and then all go back to their default
settings(default user: admin; default pw: 123456);
¾ Wired network interface.
Note:
¾ When connect to the power, the red LED will be on, if not, please
check the power adapter;
¾ Green LED indicates the working status for NVR. When it worked
properly, the indicator will be always on;
¾ Blue LED indicates the working status for hard disk. After found the
hard disk, it will be always on; when read-write hard disk it is flashing.
4
Preparation
Following preparations should be done before recording:
¾ We do not provide the hard disk by default, users may use their own
hard disks, the interface is SATA, can support max 2T storage.
¾ Installation for hard disk：open the cover of NVR, connect the power
line and data line to the hard disk, and fix the hard disk to the base,
then close the cover，as figure 3.
4