General Pump SK Repair Manual - Manual (Page 21)

GENERAL PUMP
A member of the Interpump Group
SK SERIES
Page 21
Mount one of the PTO bearing covers (left or right) on the pump casing (1, fig. 68) and attach it with 4
M8 x 30 screws (1, fig. 69).
Be careful of the direction of assembly of the cover. The lubrication hole in the cover must
correspond to the hole in the casing.
Repeat the operations on the other side:
Insert the internal ring (1, fig. 62) and external ring (1, fig. 63) of the second bearing.
Mount the second PTO bearing cover on the pump casing (1, fig. 68) and attach it with 4 M8 x 30 screws)
(1, fig 69).
Set the 4 screws with a torque wrench, as shown in Section 3).
Pre-assemble the two bearing support covers:
Insert the bearing using a mallet or striking hammer (1, fig. 70) until 4-4.5 mm of the bearing is still
protruding, as shown in fig 71.