General Pump SK Repair Manual - Manual (Page 10)

GENERAL PUMP
A member of the Interpump Group
SK SERIES
Page 10
Lay the crankshaft on the bottom of the casing. Separate the bearing support cover from the bearing, using
a striking hammer (1, fig. 26).
Unscrew the attachment screws of the left and right PTO bearing cover (1, fig. 27) and slip the two covers
off the PTO shaft. To help with their removal, use 3 M8 grub screws or screws (1, fig. 28) as extractors.
Apply an M16 threaded pin to one end of the crankshaft (1, fig. 24) and, while keeping it raised, take out the
bearing support cover complete with bearing and O-ring (1, fig. 25). To help with their removal, us 2 M10
grub screws (2, fig. 24) as extractors. Repeat the operation on the other side.