FEC MICRO NR - Manual (Page 91)

FEC Micro Nutrunner Operations Manual Chapter 7: System Operations (Rev. 2.1: 12/12)
Page 7-23
7.4.2 RS232C Display / Edit Mode
Select RS-232c port either Printer or User-console mode.
Depressing the SET button will initiate the preset edit mode and a blinking data will appear in the
[DATA] display. The blinking character can be change (select) by using the [
 ] and [  ] buttons.
This operation requiring Data confirmation and Power off and on cycle. (Check detail section)
User-console mode
Fastening data output mode
Select Fastening data output mode when using USB User-Console communication.
[  ], [  ]
Button
Set to “UC” to enable User
Console software communication
through the RS232 port.
This setting disables User Console
communication through the USB
port.
Set to “Prt” to enable data output
to an external device (IE: printer,
PLC, etc.) through the RS232 port.
This setting enables User Console
communication through the USB
port.