FEC MICRO NR User Manual

Page 76

Chapter 7: System Operations

Page 7-8

PRESS

7.2.2 Real Time Display mode.

While in the Real Time Display mode, you can choose the desired type of data by pressing the [



]

and [



] keys. The indicator will display the following data in the [DATA] area and [PAR] / [D-NO]

display area.

Torque value: The real-time torque value from the torque
transducer is displayed in the [DATA] area.
Angle (rotation): The real-time angle of rotation of the tool
output shaft (in the CW fastening direction) measured since the
last time the display mode was switched to Real Time Display

Mode (-1999



to 9999



) in shown in [PARM] / [D-NO].

NOTE: Motor Lock Function

– Activated when [SET] is pressed

during this display. (See Motor Lock Function on the following
page.)

Torque voltage: The real-time torque signal voltage from the
torque transducer is displayed in the [DATA] area.
Transducer Zero Voltage: Torque transducer origin voltage
from the torque transducer is displayed in [PARM] / [D-NO].

Month / Date: Displays Month and Date data stored in Unit.

Example:

“0604” for Jun 4th

Year: Displays two digits of the year in the [PARM] area.

Example:

“11” for

Hour / Minute: Displays Hour and Minute data stored in the Unit
(24 hour clock format) in the [DATA] area.

Example:

“1302 for 1:02PM

Second: Displays Seconds data stored in the Unit in the
[PARM] area.

Example:

“58” for 58 seconds

Memory card (SD) status: Displays memory card status.
Detailed information refer to detail section.

Memory card (SD) empty sectors: Display memory card empty
sectors in 1K sector units. New 2GB memory card (currently not
used) is 3819 K sectors.

Example: 3819 = 3,819 K-sectors

(1K Sector = 524,288 bytes)

Memory card (SD) writing time: Display memory card fastening
data writing time.

Displayed in milliseconds (“0” is displayed

when not writing).

Example: 500 = 500 msec.

FIG. 7-2-2 Real-time Display selection

The Unit's RTC (Real Time Clock) data is held by
batteries. If date data is lost after powering down, check
for low battery.