FEC MICRO NR - Manual (Page 87)

FEC Micro Nutrunner Operations Manual Chapter 7: System Operations (Rev. 2.1: 12/12)
Page 7-19
7.3.2 Data Edit Mode
After you have selected the Parameter number and the Data number you would like to edit, press
the [SET] button to enter the Data Edit mode.
The blinking digit will now appear at the left digit of the [DATA] field. You can move one digit to
the right each time you press the [MODE] button. By pressing the button four times, you leave the
Data Edit mode and return to the Setup mode (without saving any changes). Use the [
 ] and [  ]
buttons to increase or decrease the digit that is blinking.
After changes have been made, pressing the [SET] button will return you to the Parameter
Display mode.
If the entered values are out of range / limits, "Err" will appear, and the new data will be ignored.
In this case, return to the parameter number selection (using the [MODE] key) and enter data that
is acceptable.
NOTE: Data will not store until the confirmation [Y or N] process has been completed.
FIG. 7-3-2 Setup mode operation
MODE MODE MODE
SET
① ② ③ ④
Parameter display mode
SET SET SET
MODE
PAGE 7-11