FEC MICRO NR - Manual (Page 90)

Chapter 7: System Operations
Page 7-22
7.4.1 Torque Unit Display / Edit Mode
Pressing the [SET] button will initiate the preset edit mode and a blinking data will appear in the
[DATA] display.
The blinking character can be changed (selected) by using the [
 ] and [  ] buttons.
Note: All parameters will be changed to the selected torque unit.
Torque unit selection:
Nm Kgm Kgcm
Ft lbs Inch lbs Ncm
When the Torque Unit parameter is changed, all fastening parameters (01 ~ 08) are
cleared. All parameter data must be re-entered and verified after changing this parameter.