Gardner Bender HH-113 Hi-Hoist - Manual (Page 3)

3. Raise the hoist by pulling the upper lock
pin(Figure 3) and rotating it 1/4 turn left. The
center shaft can be raised to 10 feet by turning
the ratchet crank. When the desired height is
reached, be sure the ratchet lock engages in a
tooth on the cable drum to prevent accidental
movement.
Maximum hi-hoist lifting
capacity is 100 lbs. Do NOT
attempt to lift objects heavier than 100 lbs.
4. Lower the hoist and turn the upper lock pin
1/4 turn right to lock shaft in place.
5. To extend the hoist to the maximum 13 feet,
pull and turn the upper lock pin left. Turn the
crank until the hoist stops rising.
Pull and turn the lower lock pin(Figure 3).
Continue cranking until the maximum height is
reached.
6. For greater stability and strength during
heavy lifts up to 10 feet, pull the lower lock pin.
Leave the upper lock pin engaged. When
cranking, the two shafts will rise together to a
maximum of 10 feet.
7.To lower the Hi-Hoist,grasp the ratchet crank
to prevent it from turning when the ratchet lock
is released. Release the ratchet lock and turn
the crank to lower the hoist.
8.Turn the upper and lower lock pins 1/4 turn
to the right to lock the shafts.