Gardner Bender HH-113 Hi-Hoist - Manual (Page 2)

DESCRIPTION
Two telescoping sections are the main support
which will permit raising the hi-hoist to 10 and
13 feet respectively. The sections are raised by
a rotating drum and aircraft cable. The col-
lapsed height is 6 feet 4 inches. Three legs
support the hoist and each leg has a caster.
One leg is stationary and the remaining two
are adjustable to allow positioning closer to
walls and partitions. The lifting cradle accepts two types of
adaptors. The straight adaptor for flat
objects(light fixtures, duct work, ceiling tiles).
The “V” shaped adaptor is used primarily for
conduit, pipe, or other rounded objects up to
21/2” in diameter.
(See Figure 1)
OPERATION
1. Select and install adaptors on the lifting cra-
dle. Straight adaptors slip over the cradle
arms;the “V” adaptors are inserted in the cra-
dle arms. (Refer to Figure 1) 2. Position the legs to provide the maximum
stability during a lift. Legs can be adjusted by
removing the cotter pin from the leg mounting
pin. Remove the mounting pin, position the leg
and reinstall the pin. The mounting pin must
extend through the two base plates and the
short end must hook into the leg hole.
(Refer to Figure 2)