Testing control surfaces – Biamp LTR User Manual

Page 81

Designing Control Surfaces

Testing Control Surfaces

Test Mode may be entered at any time during the design process, from either the

. Test Mode temporarily disables all editing of the control surface, closes the

and

(if open), and allows the operational behavior of controls to

be tested 'off-line'. Test Mode will automatically enter Full Screen mode, if selected under

. NOTE: Ctrl+F9 may be used to toggle Full Screen while still in Test

Mode. Entering Test Mode will also produce a prompt to save any changes that may have been
made to the file.

This manual is related to the following products: