I-View FSKY-100 3D/4D Joystick Keyboard - Manual (Page 8)

8
Function Description
3. CAM
Select camera ID: Enter the Speed dome ID (0-255) by the number key then press CAM
key. i.e. Number + CAM . The number will be displayed after item CAM on the LCD.
For example: You want to select the ID 128 PTZ camera, press “ 1 “ + “ 2 “ + “ 8 “ and
“ CAM “ key at a time. The LCD will show CAM=128, repeat the same process to select
and other ID.
4. MON Reverse.
5. CLOSE/OPEN, NEAR/FAR, and TELE/WIDE
This is used when controlling the actions of the IRIS, FOCUS, and ZOOM of the zoom lens
connected to the speed dome or PT camera which with Pelco Protocol.
Under Manual mode, pressing key CLOSE and OPEN can control the IRIS function.
Under Manual mode, pressing key NEAR and FAR can control the
Focus function.
Under Manual mode, pressing key TELE and WIDE can control the Zoom function
.
6. MENU
Press key MENU it gets turned on, and the OSD of Speed dome will be enable. Exit the
menu (OSD) from the exit item of the camera OSD (recommended) or press key MENU
again; it gets turned off for next call.
Press OPEN key to enter the next menu setting.
Turn the menu by pressing WIDE and TELE, adjust the parameter value by pressing FAR,
and exit the adjusting by pressing NEAR.
7. TOUR
For FDPI-27X/35X/36X, FDMO-27X/35X/36X, PTZWO-220 and SDCI-220 model:
Press key Tour, the LED will be light and star to tour the multi preset position.
Press key Tour again, the LED will be off and stop to tour the multi preset position.
For SDCI-220, PTWO-100 and PTCI-100 model:
Press key 51 + PRESET star to tour the multi preset position. Move the Joystick to stop
tour function.