American Expedition Vehicles JK HEMI Builder Kit - Installation Guide for 12+ JK Wrangler User Manual
Page 31
29
REPOSITION HOIST TO UNDER CHASSIS AND RAISE JEEP FOR UNDERSIDE ACCESS
29. Reposition the hoist under the chassis and raise the vehicle for underside access.
30. Reinstall all body mount hardware and torque to factory specifications (refer to factory service manual).
31. Reinstall shifter linkage (refer to factory service manual).
32. Reinstall drive shafts (refer to factory service manual).
33. Reconnect fuel filler and NVLD charcoal canister (refer to factory service manual).
34. Reconnect parking brake cables (refer to factory service manual).
35. Connect transmission oil cooler lines to transmission cooler. (fig 46).
Figure 46
36. Install and tighten transmission mount bolts (refer to factory service manual).
37. Reinstall skid plates (refer to factory service manual).
38. Make sure that the exhaust system has clearance around everything front to back then tighten from
the front to the back. We would also recommend welding each joint (with stainless wire) to prevent
the exhaust from shifting.