American Expedition Vehicles JK HEMI Builder Kit - Installation Guide for 12+ JK Wrangler - Manual (Page 27)

25
14. Remove horn and horn bracket located on inner fender next to the brake booster. Modify the bracket
as shown in Figure 37 to relocate horn.
REMOVE SHADED PORTION
90° BEND
BEFORE AFTER
Figure 37
VI. Body re-installation
1. Lower the body back onto the chassis. Pay special attention to all lines and wiring so as not to dam-
age or pinch anything.
2. Install and reconnect everything in the engine bay.
3. Attach the heater core lines at the fire wall.
4. Connect the lower radiator hose at the radiator.
5. Reconnect brake lines.
6. Connect brake booster.
7. Route the wiring harness to the PCM/Computer.
8. Connect the ground to the stud located next to the brake booster on the inner fender.
9. Install the horn bracket and the AEV supplied HVAC to condenser line at the original horn bracket
location (fig 38).
Figure 38