BabyTrend FB60408 - TRENDZ FASTBACK 3-IN-1 CAR SEAT - JELLY BEAN - Manual (Page 20)

37 38
10.0
Securing Toddler Seat in Your Vehicle
10.0
Securing Toddler Seat in Your Vehicle
2. Press the LATCH Release Button on each
LATCH Connector (Fig 38-1) and pull away
from the vehicle anchors. Store the LATCH
Connectors when not in use by pressing
the Yellow Release Tabs and pushing the
LATCH connector back into the car seat.
10.2 Installation with Vehicle Belt
WARNING!
DEATH or SERIOUS INJURY can occur:
FAILURE TO PROPERLY SECURE YOUR CHILD IN THE CHILD
RESTRAINT INCREASES THE RISK OF SERIOUS INJURY OR
DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP
OR CRASH.
WARNING
VEHICLE LAP BELT MUST STAY TIGHTLY ADJUSTED
TO CHILD RESTRAINT AT ALL TIMES. IF VEHICLE
BELT DOES NOT STAY TIGHT, READ VEHICLE
OWNER’S MANUAL AND “VEHICLE SEAT BELT
REQUIREMENTS” SECTION IN THIS MANUAL
IMPORTANT: The Car Seat
MUST NOT hang over the edge
of the vehicle seat. (Fig 38-2)
2. Tighten the Tether Strap securely by pulling
the free end of the Tether Strap firmly
toward you as shown. (Fig 37-1)
Note: To loosen/lengthen the Tether Strap,
press on the Tether Adjuster button while
pulling on the Tether Hook.
Remove Car Seat
• Disconnect Tether Strap.
• Store the Tether Hook and Tether
Strap when not in use.
To store the Tether Strap:
1. Lengthen the strap and slide
the Tether Hook onto the
lower edge of the booster seat
as shown. (Fig. 37-2)
2. Tighten the strap so Tether Hook is
securely held in place. (Fig. 37-3)
• Disconnect LATCH Lower Connectors
To disconnect the LATCH Connectors:
1. To detach the LATCH Connectors, press
the LATCH Extend Buttons (Fig 37-4)
and pull the car seat away from the vehicle
seat to extend the LATCH Connectors.
37-1
37-2
37-3
37-4 38-2
38-1
LATCH
relese button