beautypg.com

System initialization – Acura 2011 ZDX Navigation User Manual

Page 129

background image

128

Navigation System

System Initialization

If the navigation system finds the

satellites properly, this box clears and

the

Disclaimer

screen is shown. If

within 10 minutes the system fails to

locate a sufficient number of satellites to

locate your position, the following

screen appears:

If the system is still unable to acquire a

signal, follow the instructions on the

screen, or contact your local dealer for

assistance.

NOTE:
The average acquiring time is less than
10 minutes.

Map Matching

This part of the initialization matches

the GPS coordinates found above with a

road on the

map

screen. To perform this

part of the procedure, ensure that the

navigation system is displaying a map,

and drive the vehicle on a mapped road

(a road shown on the

map

screen). Do

not enter a destination at this time.

When the name of the current road you

are driving on appears at the bottom of

the screen, the entire procedure is

complete. Your system is now ready to

use.

Although your navigation system is one

of the most highly sophisticated pieces

of equipment you will find in a modern

automobile, you may find during its use

that it has certain limitations.

The system uses GPS signals to aid in

determining its current location.

The GPS is operated by the U.S.

Department of Defense. For security

reasons, there are certain inaccuracies

built into the GPS that the navigation

system must constantly compensate for.

This can cause occasional positioning

errors of up to several hundred feet.

For example, in urban areas where

streets are close together, this could

cause the system to show that you are

traveling on a street that parallels the

street you are actually on. The system

will, under most circumstances, correct

itself while you drive.

This manual is related to the following products: