8e6 Technologies ER3-100 (5K02-55) - Manual (Page 14)

0 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
Rack Mount Instructions for non-“H” Servers
Rack Setup Suggestions
Determine the placement of each component in the rack before you install the rails.
Install the heaviest server components on the bottom of the rack first, and then work
up.
Identify the Sections of the Rack Rails
You should have received two rack rail assemblies with the 8e6 server unit. Each of
these assemblies consists of two sections: An inner fixed chassis rail that secures to the
unit (A), and an outer fixed rack rail that secures directly to the rack itself (B). A sliding
rail guide sandwiched between the two should remain attached to the fixed rack rail. The
A and B rails must be detached from each other in order to install.
To remove the fixed chassis rail (A), pull it out as far as possible. You should hear a
“click” sound as a locking tab emerges from inside the rail assembly and locks the inner
rail. Then depress the locking tab to pull the inner rail completely out. Do this for both the
left and right side rack rail.
•
•