Yamaha CDR-S1000 - Manual (Page 25)

E-22
RECORDING FUNCTIONS
English All Track Erase
1
Load a CD-RW disc that has been recorded on.
• This function is not possible on a finalized
CD-RW disc.
2
Press ERASE until “Erase ALL?” appears on the
display.
• If you want to cancel the Erase mode, press
&
( STOP & on the remote).
3
Press ^ ( PLAY # on the remote) to start the All
Track Erase process.
• This process requires from several seconds up to 3
minutes depending on the amount of recorded
material.
• During All Track Erase, “Erase” and the remaining
time to completion appear in the display.
4
The recorder stops when All Track Erase is complete.
TOC Erase
1
Load a CD-RW disc that has been finalized.
2
Press ERASE .
• “Erase TOC?” appears in the display.
• If you want to cancel the Erase mode, press
&
( STOP & on the remote).
3
Press ^ ( PLAY # on the remote) to start the TOC
Erase process.
• This process requires approximately 1 minute to
complete.
• During TOC Erase, “Erase” and the remaining time
to completion appear in the display.
4
The recorder stops when TOC Erase is completed.
Note
• When TOC Erase is complete, the TOC indicator goes out.
Disc Erase
1
Load a CD-RW disc that has been recorded on.
• The CD-RW disc may be finalized or not.
2
Press and hold ERASE for about 2 seconds.
• “Erase DISC?” appears in the display.
• If you want to cancel the Erase mode, press
&
( STOP & on the remote).
3
Press ^ ( PLAY # on the remote) to start the Disc
Erase process.
• This process requires approximately one-fourth the
total time on the disc.
4
The recorder stops when Disc Erase is completed.