Yamaha CDR-S1000 - Manual (Page 21)

E-18
RECORDING FUNCTIONS
English
Manual track marking
NATURAL SOUND CD RECORDER CDR-S1000
POWER FINALIZE ERASE DISPLAY
TRACK NO. EFFECT REC MODE
OPEN/CLOSE
CD DIRECT REC
INPUT
PHONES
REC LEVEL
LEVEL
DIGITAL/ANALOG
MIN MAX
0 10
OPTICAL COAXIAL ANALOG
REC MUTE
/ / /
EFFECT
FINALIZE
STOP PAUSE PLAY
SEARCH SKIP
ERASE REC REC MUTE
1 2 3
4 5 6
7 8 9
+10
0
INDEX
REPEAT RANDOM CLEAR PROG
REC MODE
TRACK NO.
WRITE DIMMER DISPLAY
OPEN/
CLOSE TRACK NO.
WRITE
TRACK NO.
Recording directly
from a source CD
NATURAL SOUND CD RECORDER CDR-S1000
POWER FINALIZE ERASE DISPLAY
TRACK NO. EFFECT REC MODE
OPEN/CLOSE
CD DIRECT REC
INPUT
PHONES
REC LEVEL
LEVEL
DIGITAL/ANALOG
MIN MAX
0 10
OPTICAL COAXIAL ANALOG
REC MUTE
/ / /
Because CD discs are recorded at a sampling rate of 44.1
kHz, this unit makes it possible to make a direct recording
of another CD disc that bypasses unnecessary digital
processing such as the sampling rate converter.
CD DIRECT
CD DIRECT
1
Press CD DIRECT while in record pause mode.
• When the CD DIRECT function is on, the CD
DIRECT indicator lights.
2
Perform one of the recording procedures as outlined
on pages 13 to 16.
• Any of the recording modes may be used.
• When the CD DIRECT indicator is lit, recording
level adjustment is not possible. Additionally,
dynamic range compression cannot be applied to
the recording.
To turn off the CD DIRECT function
Press CD DIRECT again.
Note
• Due to variances in recordings, the CD DIRECT function may
not work with all CD discs. If the CD DIRECT function is not
possible, pressing CD DIRECT causes the CD DIRECT
indicator to blink for 3 seconds and then turn off.
While recording, press TRACK NO. ( TRACK NO.
WRITE on the remote).
• A new track number is added at the location on the disc
corresponding to the time TRACK NO. ( TRACK NO.
WRITE on the remote) is pressed.
• Please note that tracks cannot be shorter than 4 seconds,
and that a disc cannot contain more than 99 tracks.
Even if there is time remaining on the disc, further
recording is impossible once 99 tracks have been
recorded.
Notes
• When digitally recording DAT sources, be sure to start
recording on the CD-R disc after pausing the source at the
beginning of a track (start ID, etc.).
• Manual track marking is recommended for the following:
* When an analog source is being recorded that contains a
section or numerous sections with levels too low to be
detected on the level meter.
* When recording digital satellite broadcasts
• Manual track marking is possible even during synchronized
recording.
You can manually mark tracks as you like anywhere in
your recording.