Yamaha CDR-S1000 - Manual (Page 24)

E-21
RECORDING FUNCTIONS
CD-RW discs can be erased and new recordings can be
made after material has been erased. The following types
of erasing are possible with this unit.
Last Track Erase
Erases the last track. This operation is not possible on a
CD-RW disc that has been finalized or when only one
track has been recorded on the disc.
All Track Erase
Erases all of the tracks recorded on the disc. This
operation is not possible on a CD-RW disc that has been
finalized.
TOC Erase
TOC Erase is only available on a CD-RW disc that has
been finalized. After the TOC is erased, the effects of
finalization are defeated, and further recording is possible.
Disc Erase
This operation deletes all data on the disc. It is usually not
necessary to perform this function, however, it may be
used to recover a disc that was stopped during a
finalization or erase operation, etc.
To select an erase mode
Each time ERASE is pressed, the Erase mode changes as
follows.
CD-RW discs that have not been finalized:
Erase off = Last Track Erase = All Track Erase
Finalized CD-RW discs:
Erase off = TOC erase
All CD-RW discs:
Holding down
ERASE for at least 2 seconds initiates
Disc Erase.
Note
• When there is only one track recorded on a CD-RW that has
not been finalized, only All Track Erase is possible.
IMPORTANT
• Do not turn off the power during an erase
procedure as this could cause the player to
malfunction and make the disc unusable.
• If the message “Check Disc” appears during an
erase operation and erasing stops, the disc may be
damaged. Should this occur, inspect the disc and
then try erasing it again.
Last Track Erase
1
Load a CD-RW disc that has been recorded on.
• This function is not possible on a finalized
CD-RW disc.
2
Press ERASE .
• “Erase LAST?”, appears in the display.
• If you want to cancel the Erase mode, press
&
( STOP & on the remote).
3
Press ^ ( PLAY # on the remote) to start the Last
Track Erase process.
• This operation requires several seconds to
complete.
• During Last Track Erase, “Erase” and the
remaining time to completion appear in the display.
4
The recorder stops when Last Track Erase is
complete.
Track and Disc Erase
(CD-RW discs only)
±
EFFECT
FINALIZE
STOP PAUSE PLAY
SEARCH SKIP
ERASE REC REC MUTE
1 2 3
4 5 6
7 8 9
+10
0
INDEX
REPEAT RANDOM CLEAR PROG
REC MODE
TRACK NO.
WRITE DIMMER DISPLAY
OPEN/
CLOSE
NATURAL SOUND CD RECORDER CDR-S1000
POWER FINALIZE ERASE DISPLAY
TRACK NO. EFFECT REC MODE
OPEN/CLOSE
CD DIRECT REC
INPUT
PHONES
REC LEVEL
LEVEL
DIGITAL/ANALOG
MIN MAX
0 10
OPTICAL COAXIAL ANALOG
REC MUTE
/ / /
ERASE
ERASE
PLAY #
^ &
STOP &