Adding accessories modules, Expansion module compatibility – Xtant M Series User Manual
Page 17
16
Adding Accessories Modules
Xtant offers two types of accessory modules which
are designed for either “Horizontal” or “Vertical”
mounting. The docking port(s), located on the amplifi-
er’s circuit board, labeled Horiz Acc Port will accept any module,
while the port(s) labeled “Vert” will only accept modules designed
for vertical mounting. Please refer to the following list for mod-
ule/amplifier compatibility as well as their mounting orientation.
Expansion Module Compatibility
M Series
A Series
X Series
Mounting
NGM 1
yes
yes
Incl.
Horizontal
CM 24x
yes
yes
Incl.
Horizontal
PQM 1
yes
yes
yes
Horizontal
LFQ 45
yes
yes
yes
Vertical
CM 12
H
yes
yes
N/A
Vertical
CM 12
L
yes
yes
N/A
Vertical
RM 4
no
yes
Yes
Horizontal
RM 8
no
yes
Incl.
Horizontal
RM 12
no
yes
Yes
Horizontal
RM 16
no
yes
Yes
Horizontal
RGM 1
yes
yes
yes
Horizontal
The accessory ports allow you to add the level(s) of signal pro-
cessing that you desire. For example, if a band pass crossover is
desired, a CM 12
H
(high pass at the lowest frequency of the band
pass) and a CM 12
L
(low pass at the highest frequency of the band
pass) could be used to create a 12 dB per octave band pass filter.
A more basic set-up would be a PQM-1 EQ module and a CM 12 (
L
or
H
)
crossover module.