beautypg.com

Using auto setup, Optimizing the speaker setting, For your listening room – Yamaha DSP-AX861SE User Manual

Page 30: P. 28

background image

OPTIMIZING THE SPEAKER SETTING FOR YOUR LISTENING ROOM

28

En

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.

• Be advised that it is normal for loud test tones to be output

during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as

possible while the “AUTO SETUP” procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.

y

• You can run “AUTO SETUP” using the system menu that

appears in the OSD or in the front panel display. This manual
uses the OSD illustrations to explain the “AUTO SETUP”
procedure.

• Before performing operations, set the operation mode selector

on the remote control to

L

AMP.

• This unit uses the speakers connected to the FRONT A speaker

terminals as the front speakers for the adjustment.

1

Make sure of the following check points
before starting the AUTO SETUP operations.
❏ Speakers are connected appropriately.

❏ Headphones are disconnected from this unit.

❏ This unit and the video monitor are turned on.

❏ The connected subwoofer is turned on and the

volume level is set to about half way (or slightly
less).

❏ The crossover frequency controls of the

connected subwoofer is set to the maximum.

❏ The room is sufficiently quiet.

2

Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.

The following menu screen appears on the video
monitor.

3

Place the optimizer microphone at your
normal listening position on a flat level
surface with the omni-directional
microphone heading upward.

y

It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would
be when you are seated in your listening position. You can
use the attached screw of a tripod (etc.) to fix the optimizer
microphone to the tripod (etc.).

Optimizing the speaker setting for your listening room

Using AUTO SETUP

Notes

VIDEO AUX

OPTIMIZER MIC

S VIDEO

VIDEO

AUDIO

OPTICAL

L

R

Omni-directional
microphone

AUTO:MENU

PRESENCE

NONE

. EXTRA SP ASSIGN

>FRONT B

SETUP

;;;;;;;AUTO

EQ

;;;;;;;NATURAL

START

[ ]/[ ]:Up/Down
[ ]/[ ]:Select

[

[

[

[

Optimizer microphone