beautypg.com

Setting the speaker impedance, Turning this unit on and off – Yamaha DSP-AX861SE User Manual

Page 27

background image

25

En

Connections

PRE

P

ARA

T

ION

English

1

Make sure this unit is turned off.
Refer to the right column for details.

2

Press and hold 5

TONE CONTROL on the

front panel and then press 1

STANDBY/ON

to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.

3

Rotate the 6

PROGRAM selector on the

front panel to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8

Ω MIN”) appear in the front panel display.

4

Press 5

TONE CONTROL on the front

panel repeatedly to select “6

MIN”.

5

Press 1

STANDBY/ON on the front panel to

save the new setting and turn off this unit.

The setting you made is reflected next time you turn on this
unit.

Turning on this unit

Press

1

STANDBY/ON

on the front panel to

turn on this unit.

y

When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.

Set this unit to the standby mode

Press

1

STANDBY/ON

(or

H

STANDBY

) to

set this unit to the standby mode.

In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.

y

• You can also turn on this unit by pressing

3

SCENE (or

A

SCENE) buttons.

• When you turn on this unit, there will be a 4 to 5-second delay

before this unit can reproduce sound.

Setting the speaker impedance

Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6

Ω MIN” as follows BEFORE using this unit. 4 ohm

speakers can be also used as the front speakers.

Note

TONE CONTROL

STANDBY

/ON

While holding

down

Turning this unit on and off