Yamaha EMX100CD - Manual (Page 18)

E-10
If desired, you can adjust brightness of the display.
1
Press and hold the DISPLAY button for more than 2
seconds so that “DIMMER±0” appears on the display.
2
Holding the DISPLAY button pressed, turn the VOLUME
control clockwise to increase or counterclockwise to
decrease brightness.
This adjustment can be made even though the power of this
unit is off (in the standby mode).
Control range
When the power is on: ±0 to –6 (Preset value: ±0)
When the power is off: +3 to –3 (Preset value: ±0)
ADJUSTING BRIGHTNESS OF THE DISPLAY
(See figure B on page 8 8 .)
• Be sure that your headphones have a 3.5 mm (1/8”)
diameter plug and are between 16 ohms and 50 ohms
impedance. Recommended impedance is 32 ohms. • When headphones are connected, the speakers are
defeated automatically and you can listen to the sound to
be output from the front speakers through headphones.
Adjust the VOLUME control for desired volume.
LISTENING WITH HEADPHONES
(See figure 0 on page 8 8 .)
1
While the power is on, press the DISPLAY button to
display the time. If the power is off, you can proceed to the
next step.
2
While holding the TIME ADJ button pressed, press the
HOUR button and set the hour.
*
Press the HOUR button once to advance the time by 1
hour. Press and hold to advance continuously.
3
While holding the TIME ADJ button pressed, press the
MIN button and set the minute.
*
Press the MIN button once to advance the time by 1
minute. Press and hold to advance continuously.
Singapore model use a 24-hour display. For General
model uses, either the 24-hour display or the 12-hour
display is selected depending on the setting of the
FREQUENCY STEP switch on the rear panel, so you
cannot select a desired type freely.
In the event of a power failure or when the AC supply
lead is disconnected.
The time display will go out, however, the clock will function
for about 5 minutes without power supply. So you do not
have to reset the time if the AC power supply is resumed
within about 5 minutes.
When the AC power supply is resumed after more than 5
minutes pass without power supply, the time display will flash
on and off to indicate that the time must be reset.
(See figure A on page 8 8 .)
Front panel operation
Rotate the VOLUME control to the “UP” direction to increase
the volume, and to the “DOWN” direction to decrease the
volume.
Remote control operation
Press the VOLUME + button to increase the volume and the
VOLUME – button to decrease the volume.
* Adjusted volume level is shown by the volume level meter
and in figures on the display.
VOLUME CONTROL
SETTING THE CLOCK