Yamaha HTR-5990 - Manual (Page 64)

60
EDITING SOUND FIELD PARAMETERS
3
Select the sound field program you want to
adjust.
4
Press k / n to select the parameters.
5
Press l / h to change the parameter value.
When you set a parameter to a value other than the
factory preset, an asterisk mark (*)
appears by the parameter name
on the video monitor.
6
Repeat steps 3 through 5 as necessary to
change other program parameters.
• The available parameters may be displayed on more than one
OSD page for some of the programs. To scroll through pages,
press k / n.
• You cannot change parameter values when MEMORY GUARD
is set to ON. If you want to change the parameter values, set
MEMORY GUARD to OFF (see page 84).
■ Resetting parameters to the factory
values
To reset a certain parameter
Select the parameter you want to reset, then press l / h
repeatedly until the asterisk mark (*) next to the parameter
name disappears from the video monitor.
To reset all parameters
Use PARAM. INI (see page 85).
Notes
MUSIC
P . I N I T . D L Y ;;21ms
P . R O O M S I Z E ;;1.0
S . I N I T . D L Y ;;31ms
S . R O O M S I Z E ;;1.0
. P o p / R o c k
D S P L E V E L ;;;;0dB
1 2 B
THX STANDARD SELECT EXTD. SUR
STEREO MUSIC ENTERTAIN MOVIE
3 4 2 1
9 0 +10 ENT.
5 6 7 8
A SPEAKERS MEMORY
Sound field category
Parameters Parameter values
Cursor
A-E/CAT.
ENTER
PRESET/CH
A-E/CAT.
ENTER
PRESET/CH
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost
in case the power cord is disconnected from the AC
wall outlet for more than one week.