Yamaha HTR-5990 - Manual (Page 109)

105
ZONE 2/ZONE 3
AD
V
A
N
C
ED
OPERA
T
ION
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate VOLUME on the front panel (or press VOLUME
+/– on the remote control) to adjust the volume level of the
selected zone.
Control range: –80 dB to +16.5 dB
Control step: 0.5 dB
VOLUME +/– can be used only when ZONE2 VOL or ZONE3
VOL is set to VAR in ZONE SET (see page 85).
y
Press MUTE to mute the sound output to the selected zone.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Press CH +/– and TV VOL +/– on the remote control to
adjust the high-frequency response (TREBLE) and the
low-frequency response (BASS) respectively.
Control range: –10 dB to +10 dB
Control step: 2 dB
Check that “ZONE 2” or “ZONE 3” is displayed in the display
window of the remote control before you adjust the tonal quality
of the corresponding zone (see page 104).
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
TONE CONTROL on the front panel. For details, see “Adjusting
the tonal quality” on page 36.
POWER and STANDBY on the remote control work
differently depending on the selected zone that appears in
the display window.
• When the normal, Zone 2 or Zone 3 mode is selected,
you can turn on this unit, Zone 2 or Zone 3 or set them
to the standby mode individually.
• When the all mode is selected, pressing POWER turns
on this unit, Zone 2 and Zone 3 simultaneously and
pressing STANDBY sets them to the standby mode
simultaneously.
In the normal mode, MAIN appears for a few seconds when
POWER or STANDBY is pressed.
Note
Note
VOLUME
+
–
VOLUME
or
TV VOL
+
–
CH
+
–
Using the control mode of Zone 2
and Zone 3
Control mode LCD display
POWER
and
STANDBY
Normal mode Name of component
Turns on the main
unit only or sets it to
the standby mode.
Zone 2 mode
“ZONE 2” or “2:name
of the selected
component” Turns on Zone 2 or
sets it to the standby
mode.
Zone 3 mode
“ZONE 3” or “3:name
of the selected
component” Turns on Zone 3 or
sets it to the standby
mode.
All mode “ALL”
POWER: turns on
the main unit, Zone 2
and Zone 3.
STANDBY: sets the
main unit, Zone 2
and Zone 3 to the
standby mode.
Note