Yamaha RX-V757 - Manual (Page 64)

62
SET MENU
Use to reassign digital input/outputs, select the input mode
or rename your inputs.
■ Input/output assignment
A)I/O ASSIGNMENT
You can assign jacks according to the component to be
used if this unit’s initial settings do not correspond to your
needs. Change the following parameters to reassign the
respective jacks and effectively connect more components.
Once the inputs have been reassigned, you can select the
corresponding component by using INPUT on the front
panel or the input selector buttons on the remote control.
For COMPONENT VIDEO jacks A ( CMPNT-V
INPUT [A] ) and B ( CMPNT-V INPUT [B] )
Choices: [A] DVD , DTV/CBL, V-AUX, VCR1,
DVR/VCR2
[B] DVD,
DTV/CBL , V-AUX, VCR1,
DVR/VCR2
For OPTICAL OUTPUT jack 1 ( OPTICAL OUT (1) )
Choices: PHONO, CD, MD/CD-R , DVD, DTV/CBL,
V-AUX, VCR1, DVR/VCR2
For OPTICAL INPUT jack 2 ( OPTICAL IN (2) ),
3 ( OPTICAL IN (3) ) and 4 ( OPTICAL IN (4) )
Choices: (2) PHONO, CD, (TUNER*), MD/CD-R , DVD,
DTV/CBL, VCR1, DVR/VCR2
(3) PHONO, CD, (TUNER*), MD/CD-R,
DVD ,
DTV/CBL, VCR1, DVR/VCR2
(4) PHONO, CD, (TUNER*), MD/CD-R, DVD,
DTV/CBL , VCR1, DVR/VCR2
* DSP-AX757SE only
For COAXIAL INPUT jacks 5 ( COAXIAL IN (5) )
and 6 ( COAXIAL IN (6) )
Choices: (5) PHONO, CD , (TUNER*), MD/CD-R, DVD,
DTV/CBL, V-AUX, VCR1, DVR/VCR2
(6) PHONO, CD, (TUNER*), MD/CD-R, DVD,
DTV/CBL, V-AUX, VCR1, DVR/VCR2
* DSP-AX757SE only
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
2 INPUT MENU
. A)I/O ASSIGNMENT
B)INPUT MODE
C)INPUT RENAME
D)VOLUME TRIM
[ ]/[ ]:Up/Down
[ENTER]:Enter
2 INPUT MENU
p
p
. [A];;;;; DVD
( DVD )
[B] ;;;;;DTV/CBL
(DTV/CBL )
CMPNT-V INPUT
. (1);;;;;MD/CD-R
(MD/CD-R )
OPTICAL OUT
Notes
. (2);;;;;MD/CD-R
(MD/CD-R )
(3) ;;;;; DVD
( DVD )
(4) ;;;;;DTV/CBL
(DTV/CBL )
OPTICAL IN
. (5);;;;; CD
( CD )
(6) ;;;;; DVD
( DVD )
COAXIAL IN