Yamaha 205M EN - Manual (Page 135)

Making Global and Other Important Settings — Function
135 CVP-205/203
Changing the Automatically Selected Voice Settings — Voice Set
When changing voices (selecting a voice file), the settings best matching the voice — the same as those set in the Sound
Creator — are always and automatically called up. From this page , you can set the on/off status for each part. For
example, each of the preset voices has its own LEFT PEDAL setting; however, even changing voices will not change the
LEFT PEDAL setting, if it is set to "OFF" in this page.
The explanations here apply to step #3 of the procedure on page 125.
Use these to select the
desired part.
These determine whether the corresponding
voice-related settings (Voice selection, Effects,
Harmony/Echo, and left pedal assignment) are
automatically called up or not when you select
a voice. These settings can be turned on or off
independently for each part.
Normally, these should all be
set to "ON."
Harmony/Echo and Left
pedal assignment cannot be
set for the Layer and Left
parts.
Setting Harmony and Echo
Determines the Harmony type.
For details, see page 136.
Determines the lowest velocity value at
which the harmony note will sound. This
allows you to selectively apply the harmony
by your playing strength, letting you create
harmony accents in the melody. The
harmony effect is applied when you play
the key strongly (above the set value).
Determines the level of the Harmony effect.
Determines the speed of the Echo, Tremolo, and Trill
effects. This parameter is only available when Echo,
Tremolo, or Trill is selected in Type above.
This lets you assign the Harmony
effect to various parts. For details,
see page 136.
When this is set to “ON,” the Harmony
effect is applied only to the note that
belongs to a chord played in the Auto
Accompaniment section of the keyboard.
This parameter is not available when Multi
Assign, Echo, Tremolo, or Trill is selected in
Type above.