Yamaha MT8XII - Manual (Page 19)

12
Touring the MT8XII
MT8XII—Owner’s Manual
are output. Up to four group signals can be output simultaneously. A track must be selected for
recording using the [REC SELECT] buttons for the group signal to be output. Group signals 1
through 4 can be output to GROUP OUTs 1 through 4 or GROUP OUTs 5 through 8. This is
determined by the individual [REC SELECT] switches. For example, group signal 2 can be out-
put to either GROUP OUT 2 or GROUP OUT 6, using REC SELECT button [2–6].
During playback, the eight tape signals are output.
C SYNC IN/OUT & INPUT LEVEL control
These phono jacks are used to connect FSK and SMPTE synchronization signals. The INPUT
LEVEL control is used to adjust the level of the incoming SYNC signal that’s recorded onto
Track 8.
D PHANTOM POWER ON/OFF switch
This switch is used to turn on and off the phantom power for the XLR-type MIC/LINE (BAL)
inputs on channels 1 and 2. Phantom power is used to power condenser microphones. It should
be turned off when devices other than condenser microphones are connected to those inputs.
Front Connectors
1 PHONES
A pair of stereo headphones can be connected here for monitoring. The headphone signal is
the same as the MONITOR OUT signal.
2 PUNCH I/O
An optional footswitch, such as the Yamaha FC5, can be connected here for foot-controlled
punch in/out.
1 2