Special commands, Pause duration, Begin new rule – Wasp Bar Code Wasp Duraline WLS 8400 FZ User Manual
Page 225: Save rule, Special commands -9, Pause duration -9 begin new rule -9 save rule -9, Which allows the

Advanced Data Formatting
10-9
Special Commands
Pause Duration
This parameter along with the Send Pause parameter on page 10-33 allows a pause to be
inserted in the data transmission. Pauses are set by scanning a two-digit number (i.e., two
bar codes), and are measured in 0.1 second intervals. For example, scanning bar codes “0”
and “1” inserts a 0.1 second pause; “0” and “5” gives a 0.5 second delay. Numeric bar
codes begin on page
in
. In case of an error, or to
change the selection, scan Numeric Cancel on page D
Pause Duration
Begin New Rule
Scan this bar code to start entering a new rule
.
Begin New Rule
Save Rule
Scan this bar code to save the entered rule.
Save Rule
This manual is related to the following products: