Ultimate Technology 500 POS - Manual (Page 33)

25
Table 3. Local Mode Programming Instructions - Continued
Note: *Default Settings
Function Code(s) Operation Normal Indication Remarks
23 or 33
Main Port 0 (23)
AUX Port 1 (33)
Handshaking
1. While in programming mode, at Series 500 Keyboard numeric keypad, enter Function
Code 23 (Port 0) or 33 (Port 1).
LED (2) turns on.
2. At Series 500 Keyboard numeric keypad, enter the applicable number (0, 1, 2 or 3) to
select handshaking per list below.
0 = None
1 = CTS/RTS
2 = XON/XOFF
3 = Both*
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
optional 3-position keyswitch, move switch out of the AUX position.
24 or 34
Main Port 0 (24)
AUX Port 1 (34)
Word Length
1. While in programming mode, at Series 500 Keyboard numeric keypad, enter Function
Code 24 (Port 0) or 34 (Port 1).
LED (2) turns on.
2. At Series 500 Keyboard numeric keypad, enter the applicable number (7 or 8) to
select word length per list below.
7 = 7 data bits
8 = 8 data bits
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
optional 3-position keyswitch, move switch out of the AUX position.