Ultimate Technology 500 POS - Manual (Page 31)

23
Table 3. Local Mode Programming Instructions - Continued
Note: *Default Settings
Function Code(s) Operation Normal Indication Remarks
4. Program the next function code or exit programming mode by entering 99
on Series 500 Keyboard numeric keypad or by swiping the
Programmer's card. If using the optional 3-pos ition keyswitch, move
switch out of the AUX position.
19
MSR Send
1. While in programming mode, at the Series 500 Keyboard numeric keypad, enter
applicable Function Code 19.
LED (2) turns on.
2. At the Series 500 Keyboard numeric keypad, enter the applicable number (0 or 1) per
list below to select MSR data from one or both good tracks.
0 = send any good track*
1 = send only if all enabled tracks good
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
optional 3-position keyswitch, move switch out of the AUX position.
20 or 30
Comm (RS232)
Main Port 0 (20)
AUX Port 1 (30)
Baud Rate
1. While in programming mode, at the Series 500 keyboard numeric keypad, enter
Function Code 20 (Port 0) or 30 (Port 1).
LED (2) turns on.
2. At Series 500 Keyboard numeric keypad, enter the applicable number (1 through 9)
to select baud rate per list below.
1 = 300 6 = 9600*
2 = 600 7 = 19200
3 = 1200 8 = 38400
4 = 2400 9 = 57600
5 = 4800
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
optional 3-position keyswitch, move switch out of the AUX position.