beautypg.com

Assembl – United States Stove Company 1800GC User Manual

Page 7

background image

FUEL DOOR
ILLUSTRATION

ASH DOOR
ILLUSTRATION

LOCK

WASHER

HEX

NUTS

ASSEMBL

ASSEMBL

ASSEMBL

ASSEMBL

ASSEMBLY INSTR

Y INSTR

Y INSTR

Y INSTR

Y INSTRUCTIONS

UCTIONS

UCTIONS

UCTIONS

UCTIONS

COMBUSTION AIR

COMBUSTION AIR

COMBUSTION AIR

COMBUSTION AIR

COMBUSTION AIR

All fires need air (specifically oxygen) to burn. Furnaces, fire-
places, and wood-burning furnaces need enough oxygen for
complete combustion of their fuels. The incomplete combustion
that takes place when a furnace is "air starved" causes carbon
monoxide (CO) to be formed in quantities that can be dangerous
inside a well-sealed house. Having a source of combustion air
from outside prevents this "air starvation" of the furnace.

Drill one 7/8" hole as illustrated for placement of the Hotblast fan
limit control.

Your furnace is shipped from the factory in four (3) packages.
1) the furnace, 2) fan limit kit, 3) draft kit. Before assembling
the furnace, check to make sure there is no shipping damage,
and that all necessary parts are located in the firebox. See parts
list below.

If you find shipping damage or any of the parts missing, contact
the dealer immediately. He will take the necessary steps to
correct the problem.

Parts List

Parts List

Parts List

Parts List

Parts List

All models include the following:

Two Door Handles

FAN LIMIT KIT

FAN LIMIT KIT

FAN LIMIT KIT

FAN LIMIT KIT

FAN LIMIT KIT

One Fuel Door Latch

Fan Limit Control

One Ash Door Latch

Fan Center

One Shaker Grate Handle

F.A.D. Box

Two 1/2" Washers

3-Speed Switch

Six 1/4" Hex Nuts

Knob

Four Lock Washers

Spin Draft

Five 1/4" Lock Nuts

One Pivot Bracket

Four Brass Coil Knobs

One 1/4" x 1" Hex Bolt

Three 1/2"-13 Lock Nuts

One 1/2" x 2 1/2" Carriage Bolt

Six 1/4" x 3/4" Hex Bolts

Smoke Door

Two 1/4" x 1-1/4" Carriage Bolts

Two Smoke Door Clips

Rod Extension

DOOR HANDLE INSTALLATION

DOOR HANDLE INSTALLATION

DOOR HANDLE INSTALLATION

DOOR HANDLE INSTALLATION

DOOR HANDLE INSTALLATION

Insert door handle into door. From rear side of door place
1/2" washer over threaded part of door handle. Then attach
1/2" lock nut, being careful not to over tighten. Handle should
turn freely.

FUEL & ASH DOOR LATCH INSTALLATION

FUEL & ASH DOOR LATCH INSTALLATION

FUEL & ASH DOOR LATCH INSTALLATION

FUEL & ASH DOOR LATCH INSTALLATION

FUEL & ASH DOOR LATCH INSTALLATION

With two 1/4" x 3/4" hex bolts, attach the door latch to the
door latch mounting bracket on the left side of door frame as
illustrated. Adjust latch until door closes securely.

7

7/8" HOLE

6" (15.24cm)

3-1/2"

(8.9 cm)

SIDE OF HOTBLAST FURNACE

HOT AIR
PLENUM

FAN LIMIT
CONTROL ON
PLENUM