NetComm IG6000 - Manual (Page 16)

Industrial Modem User Guide
YML391­3A 16
&F1 Restore non­error correction factory defaults
&F. Reset modem (clear security database/Telephone numbers)
&G0 n No guard tone generated
&G1 550 Hz guard tone generated
&G2 1800 Hz guard tone generated
&K0 Flow control disabled
&K3 RTS/CTS flow control
&K4 XON/XOFF flow control
&K5 Transparent XON/XOFF flow control
&K9 n Failsafe flow control
&M0 n Asynchronous mode
&N0 Abort dial character disabled
&N1 n Abort dial character enabled
&P0 39/61 make/break ratio (USA)
&P1 n 33/67 make/break ratio (Aus/UK)
&S0 DSR signal always asserted
&S1 n DSR signal asserted at start of handshake
&S2 DSR signal asserted at end of handshake (before CONNECT message)
&T0 Terminate current test
&T1 Local Analogue Loopback test
&T3 Local Digital Loopback test
&T4 n Grant Remote Digital Loopback test
&T5 Deny Remote Digital Loopback test
&T6 Remote Digital Loopback test
&T7 Remote Digital Loopback with Self­test
&T8 Local Analog Loopback with Self­test
&V View active configuration profile
&Vn View stored profile (n=0­3)
&V8 View differences between active and default
&Wn Save current configuration into stored profile n (n=0,1,2,3)
&Yn Select stored profile n for Power on and &D3
&Zn=x Store x as phone number n (x=0­9)
#A0 Prevent Remote Access
#A1 Allow remote access
#A2 n Allow remote access with security password
#ALMn=x Dial number/s x (x=0­9 in &Z) for remote alert n
#B0 n In 1200bps originate mode B0=V.23, B2=V.22
#B1 In 1200bps originate mode B0=V.22, B2=V.23
#C0 V.25 calling tones disabled
#C1 n V.25 calling tones enabled
#J0 Assume V.42 compatibility
#J1 n Check V.42 compatibility
#K0 Disable MNP 10
#K1 n Enable MNP 10
#K2 Enable MNP 10 for Cellular links
#MEM0 All voice features off
#MEM1 n Voice mode after S110 rings if DTR is low
#MEM2 Voice mode after S110 rings regardless of DTR
#MINI Erase Voice mode alarm message
#M0 n AT command operation
#O0 n Characters ignored if modem buffers overflow