Proton CS-32 - Manual (Page 11)

0
Getting Started (Preparation)
Ventilation recommendations:
Avoid improper installation of the product. Never position the unit where ventilation is impossible.
When installing this TV, minimal ventilation distance recommendation must be maintained
between the set, wall, furniture and tightly enclosed area. Refer to the minimum distance
guidelines shown for a safe operation.
Cleaning the screen:
The screen is coated with a special thin film to reduce reflection. If this film is damaged, uneven
colors, discoloration, scratches, and other problems that cannot be repaired may occur. Pay attention
to the following when handling the screen.
•Do not use glue or adhesive tape on the screen.
•Do not write on the screen.
•Do not allow the screen to come in contact with any hard objects.
•Do not allow condensation to form on the screen.
•Do not use alcohol, thinner, benzene or other solvents on the screen.
•Do not rub the screen forcefully.
CAUTION:
•Operate only from the power source specified (AC 00-240V) on the unit.
•Avoid damaging the AC plug and cord.
•When you are not using this unit for a long period of time, it is recommended that you
disconnect the power cord from the main outlet.
•When the source has no signal to input, TV will be “Auto Power Off” after 5 minutes.
POWER CORD CONNECTION:
Connect the power cord, after completing all other connections.
. Connect the power cord to this device.
2. Connect the power cord to the power outlet.
(1)
(2)
0 cm
0 cm
30 cm
0 cm 0 cm 0 cm
30 cm
0 cm