Pioneer PDP-4214HD - Manual (Page 15)

05 Preparation
English
15
En
Installing the Plasma Display
Locating
• Avoid direct sunlight. Maintain adequate ventilation.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
• If you place anything on the top of the Plasma Display it will not
receive enough ventilation and will not operate properly.
• Allow enough space around the upper and back parts when
installing to ensure ventilation around the backside.
Operating Environment
Operating environment temperature and humidity: +0°C to
+40°C (+32°F to +104°F); less than 80% RH (cooling vents not
blocked)
Avoid installing at the following locations:
• Under direct exposure to sunlight
• Under strong artificial light
• In high humidity
• Poorly ventilated
Preventing the Plasma Display from
Falling Over
Be sure to take special care to ensure that the Plasma
Display will not fall over.
Using a wall for stabilization
1 Attach the supplied falling prevention bolts (hooks) to the
Plasma Display.
2 Use storing cords or chains to stabilize the Plasma
Display appropriately and firmly to a wall, pillar, or other
study element.
• Perform this work in the same way for both the left and
right sides.
• Use ropes, chains and fittings that are available on the
market.
• A table or an area of the floor with adequate strength should
always be used to support the Plasma Display. Failure to do
so could result in personal injury and physical damage.
• When installing the Plasma Display, please take the neces-
sary safety measures to prevent it from falling or overturning
in case of emergencies, such as earthquakes, or of acci-
dents.
• If you do not take these precautions, the Plasma Display
could fall down and cause injury.
• The screws, hooks, chains and other fittings that you use to
secure the Plasma Display to prevent it from overturning will
vary according to the composition and thickness of the
surface to which it will be attached.
• Select the appropriate screws, hooks, chains and other
fittings after first inspecting the surface carefully to deter-
mine its thickness and composition and after consulting a
professional installer if necessary.
05 Preparation
Over 10
cm (3
15 /
16
inches)
Over 50 cm (19 11 / 16 inches)
1 Hook
2 Cord or chain
3 Fitting
06-PDP42A3HD-Eng (15-18) 05.4.20, 4:30 PM 15