Panasonic AG-DV2500P - Manual (Page 20)

E-20
ON-SCREEN DISPLAY – Status display –
(continued)
No. Item Content
3
Time code • It displays the time codes (hour, minute, second and frame).
During playback, the time codes recorded on the tape are
displayed.
TCR : time code reader data
TCG : time code generator data
DTCG : time code data input from a DV IN terminal
• The symbols for the second and frame differ according to the
framing modes. (NTSC only)
00 : 00 : 00 : 00
¥ dot (.) is used for a dropped frame.
colon (:) is used for a non-dropped
frame.
• The time code display position can be set via the COUNTER
POSI. item of the DISPLAY menu.
• The TIME CODE item can be set to turn on/off the time code
display.
• The user’s bit is not displayed.
4
VTR operation mode It displays the VTR operation modes, including:
PLAY, EJECT, FF, REW, STOP, STANDBY-OFF, STILL, REC,
REC PAUSE, A. DUB, A. DUB PAUSE, SHTL (shuttle search),
JOG (F.ADV, R.ADV), BLANK SRH (blank search), NO CAS-
SETTE (cassette not loaded), POWER OFF.
When SHTL or JOG is displayed, the speed will also be dis-
played at the same time.
• The VTR MODE item of the DISPLAY menu can be set to
turn on/off the VTR operation mode display.
Memo
If the display position of the
time code is set to the upper
right, this item will be dis-
played on the lower right.
3 2 K C H – 1 / 2 0 m i n
1 0 / 1 0 / 0 2 S T A N D B Y - O F F
1 2 : 0 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
5
4
3
5
Remaining tape It displays the remaining tape duration (minutes).
• The TAPE REMAIN item in the DISPLAY menu can be set to
turn on/off the remaining tape duration display.
• Please use the remaining tape time as a gauge.