Outline, Press the stop button to stop the tape, Unity – Panasonic HD1700pe User Manual
Page 36
36
Variable memory function
1
Register the IN point using the SET button and IN
button. There is no need to set the OUT point for
variable memory playback.
Variable memory playback operation procedure
The variable memory mode can be selected by setting
(VARMEM) on the
“ON.”
When
(VARMEM) is set to “OFF,” the variable
memory mode is canceled, and the regular mode is
established.
SD) mode has been selected as the system menu
item No.25 (SYSTEM FREQ) setting,
(VARMEM)
will no longer appear on the display and the variable
memory mode cannot be selected.
F6
F6
F6
2
Set the initial speed (j1.0k to i2.0k) using the
search dial while holding down the SET button.
3
When the SET button and PREVIEW/REVIEW
button are pressed at the same time, the tape is
automatically prerolled and played back at the
initial speed setting up to the IN point.
4
After the tape has passed the IN point, turn the
search dial to store the playback speed in the
memory.
5
Press the STOP button to stop the tape.
6
When the PREVIEW/REVIEW button is pressed,
variable memory playback is performed at the
memorized speed.
Variable memory function selection
This VTR is provided with two variable memory
functions, as follows. These functions can be used in
the variable memory mode.
Variable memory playback:
Any section of the tape can be played back at variable
speeds in the VAR mode, the changes in the speed
can be stored in the memory, and the tape can be
played back at the memorized speed.
Variable memory editing:
Using the VTR as a controller (recorder in the deck-to-
deck mode) to control the playback speed of the
player, editing can be performed in the variable speed
mode.
Outline
To perform variable memory playback operations, set
the VTR to the variable memory mode, and take the
steps below.
in accordance with the settings in the memory, and
it continues to run at the last speed stored in the
memory until the STOP button is pressed.
• Whatever is stored in the memory will be cleared
when the VTR exits the variable memory mode. It
is also cleared when the POWER switch is set to
“OFF.”
POWER
OFF
ON
HEADPHONES
PUSH
LOCK
FULL
CH CONDITION
MONITOR
FULL/FINE
REMOTE
L
R
9P
50P
RS-232C
CH
1
2
3
4
5
6
7
8
CUE
XL/L/M-cassette
Do not insert S-cassette
without adapter
EJECT
AUDIO CH SELECT
SHIFT
ABC
DEF
GHI
JKL
MNO
PQRS
PREVIEW/
REVIEW
PRE-
ROLL
A IN
A OUT
HOME
RF1
ASSEM
ADJUST
SHTL
REV
FWD
VAR
JOG
STAND BY
RECORDER INPUT CHECK
PLAYER
SERVO
EDIT
PLAY
REC
REW
STOP
FF
REC INHIBIT
PUSH-INTER
INSERT
RF2
VIDEO
UNITY
TC
CUE
AUDIO
UNITY
DIAG
MENU
TRIM
SET
IN
OUT
AUTO
EDIT
7
8
9
4
5
6
BS
TUV
WXYZ
1
2
3
ENT
0
C
T
F
F1
F2
F3
F4
F5
F6
CH
1
CH
5
CH
2
CH
6
CH
3
CH
7
CH
4
CH
8
FULL
REC
P8
REC
P8
REC
P8
REC
P8
1
5
6
4
2
3