PSC PT2000TM - Manual (Page 121)

Setting Up the Dock
User’s Guide 111
2. Plug the 25-pin connector of the cable into the cable input jack
on the back of the PT Dock (refer to
Figure D-3 ).
Figure D-3: Back of the PT Dock
3. Attach the small male plug of the PSC cable to the keyboard jack
on the workstation (refer to
Figure D-4 on page 112 ).
4. Attach the keyboard cable to the small female jack on the PSC
cable (refer to
Figure D-4 on page 112 ).
5. Turn the workstation on. The green light-emitting diode (LED)
labeled
POWER on the front panel of the PT Dock should light
up.
Power input jack Cable input jack