Planet Technology DVR-860 - Manual (Page 34)

MENU FUNCTION
-28-
“RE” is to set a reference for detection. The default value is 10, which means the DVR will compare 10 continuous
images at one time according to the sensitivity of LS, SS, TS simultaneously.
The bigger the value is, the higher sensitivity for motion detection. The highest sensitivity is 61.
8) ALARM
Select LOW / HIGH for the alarm polarity. The default alarm value is OFF.
9) PRE / NEXT (DVR-860 Only)
Select “PRE” to go to the previous page; Select “NEXT” to go the next page. Targets set in the AREA.
(2) Detection Timer
Move the cursor to “DETECTION TIMER”, and press ”ENTER”. You will see a similar screen as the following:
DETECTION DETECTION TIMER
DETECTION SETUP DATE START END
DETECTION TIMER OFF 00 : 00 - 00 : 00
DAILY 08 : 00 - 18 : 00
SUN 06 : 00 - 23 : 00
MON-FRI 18 : 00 - 23 : 00
OFF 00 : 00 - 00 : 00
OFF 00 : 00 - 00 : 00
OFF 00 : 00 - 00 : 00
Set the date, start time and end time for the detection function. The setting method is similar to “TIMER”. Please refer
to the section “6.2 Timer”.
6.4.3 Display
In this menu list, you can check and change some display settings.
Move the cursor to “DISPLAY”, and press ”ENTER”. You will see a similar screen as the following:
ADVANCE DISPLAY
CAMERA TITLE DISPLAY ON
DETECTION DATE DISPLAY ON
DISPLAY HDD INFO ON
ALERT LOSS SCREEN BLUE
REMOTE PLAYBACK INFO NORMAL
SYSTEM DWELL DURATION (SEC) 2
NETWORK DE-INTERLACE ON
BACKUP MONITOR OUT MAIN
HDD INFO OSD SETUP
EVENT LOG WATERMARK ON
The submenu items are described below:
1) TITLE DISPLAY
Select to display the channel title or not (ON / OFF).
2) DATE DISPLAY
Select to display the date or not (ON / OFF).
3) HDD INFO
Select to display HDD remaining capacity or not (ON / OFF).
4) LOSS SCREEN
Set the color for the video loss screen (BLUE / BLACK).
5) PLAYBACK INFO
Set the position where playback information will be indicated: CENTER or NORMAL (on the button of the left-hand
side of the screen).
6) DWELL DURATION (SEC)
Set the duration time of each channel in second for CALL MONITOR (2 / 4 / 8 / 16).
7) DE-INTERFACE
Select to enable or disable “DE-INTERLACE” function (ON / OFF).