Copying your tapes (dubbing), Connection, Playing (source) vcr recording (editing) vcr – Panasonic PV-V4622 User Manual
Page 36
36
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Copying Your Tapes (Dubbing)
1
Insert pre-recorded tape.
2
Insert blank tape with record tab.
Press REC, then PAUSE/SLOW
immediately to enter REC/PAUSE mode.
3
4
Press PLAY to start dubbing.
Playing VCR starts playback.
Press PAUSE/SLOW to start dubbing.
Recording VCR starts recording.
Press STOP to stop dubbing.
Caution:
Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.
Playing (Source) VCR
Recording (Editing) VCR
5
To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2
Set the VCR/ TV Selector on the Recording
VCR to “VCR.”
Dubbing tapes protected with Copy
Guard will result in poor quality
recordings.
Connection
Press STOP to stop dubbing.
Press PLAY, then PAUSE/SLOW
immediately to enter PLAY/PAUSE mode.
The operation of steps 4 and 5 must be done on the
playing and recording VCRs at the same time.
VCR
IN FROM ANT.
OUT TO TV
VIDEO OUT
AUDIO OUT
AUDIO IN
VCR
VIDEO IN
TV
VHF/UHF
R
L
R
L
R
L
R
1
2
Front of VCR
(Audio/Video In Terminals on
the front of VCR are available)
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on Recording VCR. To
monitor the dubbing, also connect a TV as shown.
Connect “L” and “R” AUDIO OUT terminals on Playing VCR to “L” and “R” AUDIO IN
terminals on Recording VCR.
In place of a Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit’s Audio/Video outputs to the Recording VCR.
Press INPUT to set VCR Input mode to LINE1
for Video Input (Rear) or to LINE2 for Video Input
(Front). (See “Selecting the Input Mode” below.)
Selecting the Input Mode
Method 1: Press INPUT repeatedly.
Channel Number
↔
↔
↔
↔
↔ LINE1 ↔
↔
↔
↔
↔ LINE2
Method 2: Press CH
/
.
Display will change as below.
• “L1” or “L2” lights on Multi-Function Display
(about 4 sec.) when LINE1 or LINE2 is selected.
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
VIDEO IN 2
L-AUDIO IN2-R
1
2
3
125
LINE1
(CABLE)
69
(TV)
or
LINE2
(Rear Connection shown.)
Note
V4622 P22-44 (2nd) [LSQT0509B].p65
2002/05/23, 18:29
36