Lucent Technologies GW-DS300N User Manual
Page 18
2
13
Chapter 2 Basic Installation & Configuration
5.Authentication and Security
ĈClick on the “Authentication
and Security” tab on the Add Profile page. According to the AP's
requirement, enter the Key value or just leave it blank, and then click
“OK” to save the settings.
6.Activate the settings
ĈEnter “Profile List” page, if you really want
to use an AP to make a wireless connection, please click “Activate” to
use this connection to surf the Internet.
See also other documents in the category Lucent Technologies Hardware:
- 9076 (150 pages)
- CELLPIPE 7820-0766-004 (48 pages)
- AnyMedia Line Access Gateway (4 pages)
- CellPipe 22A Series (2 pages)
- Stinger MS+DSL (2 pages)
- ATM Module 8-Port DS3/E3 (2 pages)
- Web Services Gateway OmniAccess 8550 (8 pages)
- 7820-0657-001 (34 pages)
- Alcatel-Lucent VPN 1200 (6 pages)
- Stinger STGRSACR-SO-ADSL2P (2 pages)
- 106433691 (7 pages)
- 2000 (2 pages)
- VPN Firewall Brick 20 (4 pages)
- 20A-USB (2 pages)
- Network Access Module (75 pages)
- Wavelength Extension Solution Metropolis (4 pages)
- Lucent Network Gateway (2 pages)
- 20H (2 pages)
- 5800 Series (88 pages)
- Cajun Switch P550R (41 pages)
- PortMaster (364 pages)
- 2300 (2 pages)
- Multiplexer and Transport System ADM 16/1 (8 pages)
- Cajun M770 (72 pages)
- DSL Element Management System NavisAccess (4 pages)
- Ethereal (199 pages)
- 3000 (586 pages)
- CellPipe 55 Series (2 pages)
- Telephone User Interface Serenade (2 pages)
- APX 1000 (4 pages)
- PacketStar PSAX (4 pages)
- DSL Access Concentrator Stinger FS+ (4 pages)
- USS-720 (96 pages)
- AnyMedia 4300 (2 pages)
- CellPipe 40H-CES (2 pages)
- Stinger Trunk Module OC-12/STM-4 (2 pages)
- Host-Based Controller Modem AT (87 pages)