Kyocera S4000 - Manual (Page 58)

50 Voice Features
Voice Features
The following features enable you to customize
the voice commands.
Automatic add
By default, your phone automatically enables
voice dialing for each new contact you add to your
Contacts list as long as the contact name contains
at least one alphabet but no more than five words
or components. You can select
Settings >
Voice Features > Automatic Add > Disabled to
disable the voice dialing for new contacts.
Voice training
You can train your phone to recognize specifically
your voice for numbers. Use voice training only
when you find your voice not recognized with
acceptable accuracy.
If your phone is having trouble recognizing your
voice, select
Settings > Voice Features >
Voice Training > OK > Train Numbers .
Follow the prompts for each number until
training is complete.
Display results
The display results enables your phone to show
either one voice recognition candidate or up to
three ones. Select
Settings > Voice Features >
Display Results and one of the following:
• Single Best presents you only one voice
recognition result.
• Three Best presents you up to three voice
recognition results.
Digit lengths
Use the digit lengths to determine whether to limit
your dialed numbers to North American numbers
or any numbers. Select
Settings >
Voice Features > Digit Lengths and one of
the following:
•
North American recognizes only digit strings
of lengths that correspond to valid North
American dialing numbers of 7-digits,
10-digits, or 1+10-digits to improve accuracy.
• Permit All allows any digit strings of 4 to
14 digit lengths.
Voice wake-up
You can activate voice dialing by saying “wake up”
twice. Select
Settings > Voice Features >
Voice Wake-Up > With Accessory to enable
calls with an accessory.
To wake up the phone:
1. Say “Wake Up” and listen for a tone.
2. Say “Wake Up” again until you hear two tones.
If the phone does not recognize your Wake Up
command, see “Voice training” on page 50.
82-K6562-1EN.book Page 50 Sunday, April 13, 2008 9:31 PM