Functions specific to the editor, Utility commands – KORG M3 User Manual

Page 28

Functions specific to the editor

These are functions that are not found on the M3, and are available only from the editor (M3
Editor, M3 Plug-In Editor).

Utility commands

Load

Loads editor data that was previously saved on the computer.

Save

Saves data from the editor to your computer as a file.

Note:

These functions load or save the data as dedicated files for the editor application.

Receive All

Receives all data from the M3 data into the editor.

Note:

The sample data of Sample mode and the sequencer performance data of Sequencer

mode are excepted.

Transmit All

Transmits all data in the editor to the M3 and writes it into internal memory.

Receive All Combi/Current Combi Bank
Receive All Prog/Current Prog Bank
Receive SEQ
Receive Global Data/Drum Kit/Formant Motion/Current Formant
Motion

Receive the correspoding data from the M3 into the editor.

Note:

Receive Formant Motion/Current Formant Motion can be used only if the EXB-

RADIAS is installed.

Transmit All Combi/Current Combi Bank
Transmit All Prog/Current Prog Bank
Transmit SEQ
Transmit Global Data/Drum Kit/Formant Motion/Current Formant
Motion

Transmit the correspoding data from the editor to the M3 and writes it.

Note:

Receive Formant Motion/Current Formant Motion can be used only if the EXB-

RADIAS is installed.

Receive Current Combi/Current Prog/1 SEQ

Receive the respective data from the M3 into the editor.