SP Studio Systems SP-12 - Manual (Page 51)

CREATING A SONG
© E-mu Systems, Inc. 1985 Page 51
Enhanced by The Emulator Archive 2002 www.emulatorarchive.com
3. When the display shows the desired trigger value, press ENTER. When
playing back the song, the trigger pulses will begin (or change, or end,
depending on what you programmed) simultaneously with the next segment
programmed into the song.
4. If you reach a step where you want to change the pulses to a different rate or
stop generating a pulse, repeat steps two and three.
3L STARTING AT A SPECIFIED POINT IN THE SONG
The SP-12 should be stopped. Activate the SET-UP module and key in 21. Enter the
song step where you want the SP-12 to begin; the display’s lower line confirms your
choice. When you press RUN/STOP to start the SP-12, it will begin at the designated
song step.
This starting point will be memorized until changed. For example, if you enter
segment mode and then return to song mode, when you start the song it will begin
playing at the previously specified song step.
Note: If you start in the middle of’ a repeat loop, the repeat instruction will be ignored
by the SP-12, and you will simply proceed to the next step after the repeat
instruction.