Sennheiser WiCOS - Manual (Page 46)

Configuring the conference system
44
Configuring the conference system
Loading the factory default settings – “ Reset “
To reset the access point and the conference units to the factory default
settings:
̈
If necessary, unplug connected system cables and network cables from
the IN system socket (RJ 45)
j , the OUT system socket (RJ 45) k and
the network socket (RJ 45) h .
̈
Switch the access point on (see page 29).
̈ Switch on all the conference units that you want to reset to the factory
default settings (see page 31).
̈
Use a pointed object (e.g. straightened paper clip) to press the reset
key
b on the access point for approx. 5 seconds.
The 3 status indicators ^ of the access point flash while you press the
reset key. All indicators and displays on the conference units light up.
The access point and the conference units are reset to the factory
default settings. The status indicators
^ of the access point and the
indicators and displays on the conference units go off once resetting is
completed. The conference units are initialized with the access point.
If you change the factory default settings via the web server, the
last settings used are loaded on a restart of the conference system.
CAUTION! Loss of settings!
If you reset the access point and the conference units to the
factory default settings, custom settings are discarded.
̈
Before resetting the devices, note down the settings used.
h
j
k
b