Sennheiser WiCOS - Manual (Page 37)

35
Running a conference
Connecting headphones (WiCOS CV and WiCOS DV only)
You can listen to the floor channel or the offered interpretation channels
(where applies) via headphones (see next section).
̈
Connect headphones with a 3.5 mm jack plug to one of the headphone
sockets
J .
You can connect mono or stereo headphones.
Listening to simultaneous interpretation (WiCOS CV and WiCOS DV only)
In order for you to be able to listen to a simultaneous interpretation of the
floor channel via headphones, the conference system has to be connected
to an interpretation system (see page 73).
̈
Ask the organizer on which channel your desired language is
transmitted.
̈
Connect headphones to your conference unit (see above).
̈
Press the CHANNEL UP key F or the CHANNEL DOWN key G to select
the desired interpretation channel.
The selected interpretation channel is output via your headphones. The
channel selection display
E shows the currently set channel, e.g. “ 07
ENG ” for channel 07 with interpretation into English (depending of the
configuration of the interpretation system). If you select “ 00 FLOOR ”,
the floor channel will be output (factory default setting).
Adjusting the headphone volume
̈
Put the headphones on.
J
J
C CV D DV
G
E
F
C CV D DV
If the channel selection display E is showing a voting result, you
can return to the channel display view by pressing the
CHANNEL UP key
F or the CHANNEL DOWN key G . The voting
result cannot be displayed again.
CAUTION! Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
̈
Before putting the headphones on, set the volume to a
minimum level.
̈
Do not continuously expose yourself to high volumes.