Sharp UX-355L - Manual (Page 70)

Sending a Fax by Automatic Dialing
68
Searching for an auto-dial number
If you don’t remember the Rapid Key or Speed Dial number in which
you have programmed a particular fax number, you can search for the
number by following the steps below. Once you have found the
number, you can dial and transmit the loaded document by simply
pressing the START/MEMORY key.
1
Load the document(s).
The display will show:
•
Set the resolution and/or contrast if
desired.
2
Press the HOLD/SEARCH key and
then the 1 key.
READY TO SEND
3
Enter the first letter of the stored
name by pressing the appropriate
number key (the key below the
marked letter) one or more times until
the letter appears in the display. If the
name begins with a special character
or number, press 1.
♦
If you don’t remember the first letter, go to Step 4 (you will scroll
through the list from the beginning).
♦
If a name wasn’t stored for the number, press 0. This will cause
numbers, not names, to appear when you scroll.
HOLD/
SEARCH
1
RESOLUTION
2
5
8
GHI JKL MNO
TUV WXYZ PQRS
ABC DEF
1
4
7
3
6
9
all.book Page 68 Wednesday, April 26, 2000 7:08 PM