Shure The SM58 Vocal Artist UHF - Manual (Page 12)

14
Shure UHF-R Wireless
Transmitter Parameters
Setting Transmitter Gain
Adjust the transmitter gain and input sensitivity so that the Audio LEDs on the receiver peak within the yellow range during use. On
the bodypack transmitter, you can change the sensitivity setting to compensate for different audio levels when connecting different
intruments or microphones to the input.
To adjust gain, turn on the transmitter and press the enter button. Scroll down to the Gain parameter or the Sens parameter
(bodypack only) and press enter again. Use the arrow keys to adjust the setting and press enter to save it ( Exit cancels without
saving).
RF Safety Mode
This special feature temporarily mutes RF broadcast. This allows you to change frequency settings on a transmitter without accidentally
“cutting in” on a channel being used by another transmitter.
1. Turn the transmitter off.
2. Hold down exit key while turning on the transmitter power (for handheld microphones, you need to pull the battery cover off the
handle). The LCD flashes while the unit is in RF safety mode.
3. Change group and channel settings as you normally would—the transmitter will not broadcast.
4. Power the transmitter off and on to exit RF safety mode.
Group ( G) and Channel (Ch). Must match the receiver’s settings.
Frequency ( MHz). Manual frequency selection in 0.025 MHz increments.
Gain ( Gain). Adjusts audio level from –10 dB to +20 dB.
Sensitivity ( Sens) (bodypack only).
Sets audio input to +15 dB, 0 dB, or –10 dB.
Name Display. 12-digit ASCII.
SHURE INC.
G:34 Ch:21
779.475MHZ
Gain +20dB
Press ENTER from the main menu to access the following parameters:
tap hold LCD Panel
Changes LCD Panel
Frequency Lock
Toggles setting. When enabled, frequency cannot be changed, and a
transmitter sync will not overwrite the frequency setting.
Power Lock
Toggles power lock. When locked, power switch does not turn off
transmitter.
RF power level setting*
Use the arrow keys to select normal (10 mW) or high power (50/100 mW**). Use the normal power setting
to conserve batteries or prevent RF overload at the receiver.
* High power setting not available with models sold in countries that prohibit its use.
** High power value varies with model.
tap hold
tap hold
hold tap
Use the following key combinations to access additional features and parameters: Lock Indicators
Power Lock
Frequency Lock